[CPMD-list] BUS error

[Veronique Van Speybroeck]

Hello,

I do not know how to solve this problem, but I experience the same.  If I
compile in 32 bit precision I do not have this.  So then you have the
flags -n32
If I compile in 64 bit precision as standard done in the makefile, I also
have this problem.  For large problems you need however the 64 bit version
to allocate the memory.  I do not know how to solve

Best regards

veronique

-----------------------------------------------------------------------
Dr. ir. Van Speybroeck Veronique
Laboratorium voor Theoretische Fysica
Universiteit Gent
Proeftuinstraat 86
9000 Gent
Tel +32-9-264.65.58  GSM : +32/474/259767
Fax +32-9-264.65.60
email : veronique.vanspeybroeck at rug.ac.be
http://inwfaxp2.rug.ac.be/~web/onderzoek/proj_3.html
-----------------------------------------------------------------------

 On Thu, 19 Sep 2002, Changrong SU wrote:

> Hello, everyone,
>
>      When I compiled the cpmd v3.53 on SGI Oringin2000,
> everything is OK and the executive file is achieved.
> However, there are BUS error when it is executed after
> "GENERATE ATOMIC BASIS SET". Does anyone has experence
> to overcome this question?
>
>
> Yours,
>
> SU Changrong
>
> Center for Atomic and Molecular NanoScience
> Department of Tsinghua University,Beijing 100084
> P.R.CHINA
>
>
>
>
>
>
>
>
>
>
> _______________________________________________
> CPMD-list mailing list
> CPMD-list at cpmd.org
> http://www.cpmd.org/mailman/listinfo/cpmd-list
>